HYDRAULIC TECHNOLOGY INC.
|
HYDRAULIC TECHNOLOGY INC.
|
|
 | Overall Dimensions - 80" long x 47" wide x 62" high x 18" deep tank ; 34" table work height. |
| Tank ID Dimensions
- 61"
long x 45" wide x 18" deep |
|
Radiator Lift Capacity - 650 lbs. |
|
Gas pressure requirements - 6.9-13.8 inches water column, 30 CFH each torch. |
|
Air Pressure Requirements - 100-150 psi. |
|
Electrical Requirements - 115/220 Volt, 60 hz, single phase. Will operate at 50 Hz with a slight reduction in max flow. |
|
Gas torches - Permanently attached to machine. Supplied with low, medium and high heating tips. |
|
Air Pressure Regulation - 0-150 psi. |
|
Air Accessories - OSHA compliant air blow gun on retractable hose and regulated air test hose with test valve. |
|
Maximum Flowrate - 75 GPM. |
|
Accessory Adapters - Complete set of plugs and adapters furnished for leak testing different sized radiators. |
|
Hoses - Two 3 ft. long hoses are included for flow testing radiators in the test stand, two 8 ft. long hoses are included for on-vehicle testing. |
|
Radiator Brackets - Adjustable bar on lifting platform to hold radiators. |
|
Paint - Two coats of MIL-P-24441, 2 part epoxy finish. |
|
Approximate Dry Wt. 625 lbs. |
Copyright (c) 1995-2012 - Hydraulic Technology Inc. - All rights reserved |
The Radiator Test and
Repair Stand with integral Flow Tester meets all requirements of military specification
MIL-S-4534C, is completely self contained and requires only connection to a source of shop
air and gas to place in operation. The Type 1b test stand is identical to Type 1a
except that Type 1b contains an integral flow tester with capacities to 75 GPM (higher
capacities are available per request). Flow measurement is
accomplished by a digital panel meter with a calibrated accuracy of plus or minus 3
percent. In addition to all the accessories and adapters included in the Type1a, the
Type 1b is also provided with two 3 ft. long hoses for flow testing radiators in the test
stand and two 8 ft. long hoses for on-vehicle testing. The
test stand is constructed from 10 gauge steel, is welded both externally and internally
and is finished with a water-resistant epoxy coating specifically designed for water tanks.
As with all our test stands, this unit available in