Tester, Hydraulic Hose Assemblies, 0-15000 psi
P/N 8801, NSN 4940-01-272-3000, A-A-52687, MIL-T-25456B; NSN
4940-01-493-1630, 8801B (shown)
This hydraulic hose tester is
manufactured to, and meets all the requirements of, military specification MIL-T-25456B
and federal specification A-A-52687. The purpose of this equipment is to provide a source
of high pressure oil for proof testing hydraulic hoses after assembly. The unit is air
operated and will supply an outlet pressure up to 15000 psi from an air supply of 100 psi.
The unit is completely self contained and is supplied with adapters to
accommodate both flared and flare less hydraulic fittings in sizes from -3 to
-16 (3/16 to 1"). Other sizes available upon request.
The discharge pressure is regulated by controlling the inlet pressure at the unit by means
of its regulator. The discharge pressure will be increased in the ratio of
approximately 150 to 1 over
the inlet air pressure. The stainless reservoir has a usable capacity of 5 gallons
with an allowance for fluid expansion. Racks and laser cut foam retainers are provided on the reservoir assembly for
storage of hose connection adapters. The unit weighs 39 lbs without oil or adapters and
may be easily transported. Although this unit was originally designed for testing
aircraft and missile hose assemblies, it can be used wherever a portable source of
hydraulic pressure is required.
A means of operator safety should always be
provided. The 8801HT-72x24x11 hydrostatic test chamber shown below
is specifically designed to be integrated with the 8801B hose test system. To configure a unit to meet your specific
configuration/size requirements, please
proceed to the Customization
Page.
Specifications:
 | Dimensions: 17' Long X 15" Wide
X 21" High
|
| Weight: 39 lbs.
|
| Discharge Pressure: 0 to 15000 psi
|
| Max Inlet Air Requirements: 8 cfm at 100
psi
|
| Reservoir Capacity: 5.5 gals.
|
| Fluids: MIL-H-5606, MIL-H-83282
or potable water
|
    
Back to Hydrostatic Testers
|